Ideas for the face of your home or building — how glass, ACP, louvers and stone-look panels combine into a modern elevation. And because we fabricate the aluminium and glass in-house across Delhi NCR, the elevation you like is one we can actually build.
Six ways a facade can look.
What a facade is made of.
Most elevations mix three or four of these. Tap through to the service that builds each one.
We don't just design it — we build it.
Concept & 3D
We set the material split and show a 3D of the elevation before anything is cut.
Engineer & quote
Glass and panels sized to the wind zone, with an itemised per-sq-m rate.
Fabricate
Aluminium and glass built in-house — ACP, glazing and shopfront to one drawing set.
Install
Phased installation and handover, coordinated with the main build.
Elevation design FAQs.
Both. We design the facade or front elevation — the material split, proportions and finishes — and then fabricate and install it in-house, so the drawing and the built elevation match. Many clients come with an architect's elevation and we value-engineer and build it.
Usually a mix: ACP or HPL panels for the solid skin, structural glazing or curtain wall for the glass, aluminium louvers or fins for shading and rhythm, and backlit signage or feature lighting. We combine them so the elevation reads as one composition.
Design is a small part; the cost sits in execution and is quoted per square metre of elevation, depending on the panel and glass spec and the building height. We give an itemised rate after a site survey rather than a flat per-elevation figure.
Yes. We produce a 3D visualisation of the proposed elevation so you can see the material split and proportions before fabrication, and adjust the finishes on screen rather than on site.
Once you have a direction, these are the services that put it on the building — all fabricated and installed in-house.